|
RevitWorks Door Factory 2015 Help
Home | Start | Action | Jamb | Panel | Handle | Trim | User | Identity | Create-Name | Glossary |
This is where the user selects the type of handles required. These can differ between double panels and the interior (swing side) and the exterior sides of the door.
Refer to the support document “Creating New Handles”
The following describes parameter setting and values that can be set for the door within the Door Factory.
All the Type and Instance parameters can be changed in Revit after the door has been created.
All parameters are classed as Family Wide Parameters, Type Parameters or Instance Parameters
.
Handle Height |
Family
wide parameter. |
|
Handle Offset |
Family
wide parameter. |
|
copyright 2014 by RevitWorks Limited | www.revitworks.com