RevitWorks Door Factory Premium 2023 Help   

 

Home | Start | Action | Jamb | Panel | HandleTrim | User | Identity | Create/Name | Glossary

 

User Components

This is where the user can select two “extra” components to be included in the door.

The Door Factory comes with a number of user components including sills and sliding door pelmets.

The User Components can "flex" with the final door family by being constrained to any or all of the following:

·          Panel Width & Height

·          Panel Faces (Interior & Exterior)

·          Jamb Faces (Interior & Exterior)

·          Rough Opening Width & Height

·          Wall Faces (Interior & Exterior)

As well as the above, the following parameters are also linked through to the relevant parameters within the final door family (if they exist)

·          “Panel Width”

·          “Jamb Width”

·          “Doorstop Width”

·          "Clear Opening Width" (for single and double doors)

·          All panel to jamb/wall tolerances (i.e. Panel to Wall Gap Side2)

·          “Panel Protrusion into Opening” (for sliding doors)

Creating New User Components

Refer to the support document “Creating New User Components

 

 

 


< back to Top

copyright 2018 by RevitWorks Limited | www.revitworks.com